
Add to Cart
Industial Aerosol Products Red Insulating Varnish with Excellent Adhension
Excellent adhension to metals, windings, coils, Air dries faster than most insulating material.
Protects surface against oil, moisture, acid and alkalis, Perfect for small field and magnet coils, penetrates oil and new winding
has excellent flexibility and water resistance. Dielectric Strength up to 2.100 volts per mile.
An insulating spray for general coating, impregnating and insulating electrical and electronic components.
superiority
·Quick Drying ·Flexible Coating ·High Dielectric Strength - 2100 vpm
·Meets Class F Requirements
APPLICATIONS
1.Bus Bars;
2.Rings and Frames;
3.Stater Windings;
4.Seals Electrical and Electronic Components;
5.Motor Windings;
6.Armatures;
7.Commulator Ends;
8.Fields Coils;
9.Transformer;
10.Switchboard Parts;
DIRECTIONS FOR USE
1.Surface should be clean, dry, free of grease, rust, dirt & wax.
2.Shake can vigorously back and forth & a rotatory motion to swirl the agitator for a few seconds after every use.
3.Spray with a steady even Back & Forth motion holding can approx 12“ from the surface to be coated, allowing paint to become
tacky between light mist coats.
4.Recoating must be done within the hour to avoid wrinkling & lifting.
5.For best results room temperature should be around 75°F.
6.To use entire contents, hold spray head and rotate can as shown until material sprays.
7.To avoid clogging of valve, spray with can upside down until only pressure escapes after every use.
8.In the event of Spray Button Getting Clogged, Pull off and clean with a fine wire.
CAUTION
Do not puncture incinerate or store above 120°F. High temperature may cause bursting. Do not place near any heat source or in
direct sunlight. Use with adequate ventilation, avoid breathing vapour, Keep out of reach of children. Flush eyes with water in case
of eye contact. In case swallowed call physician. Vapours may ignite explosively-avoid sparks, smoking etc.